Document Type : Original Article
Authors
1
Department of Engineering, Faculty of Civil Engineering, Azarbaijan Shahid Madani University, Tabriz, Iran.
2
MSc. Department of Civil Engineering, Faculty of Engineering, Azarbaijan Shahid Madani University, Tabriz, Iran
3
Assistant Professor, Department of Water Engineering, Faculty of Agriculture Engineering, Fasa University, Fasa, Iran
10.22034/iwrj.2026.15330.2676
Abstract
In this study, the three-dimensional flow pattern over a stepped spillway with a rectangular labyrinth crest equipped with sills was investigated experimentally. The edge of each step comprised eight rectangular labyrinth cells; these cells form part of the step-crest plan and are not separate elements. Rectangular sills (width equal to the labyrinth cell width, streamwise length of 3 mm, and heights of 2.4 and 3.0 cm, corresponding to 0.4h and 0.5h, where h is the step height) were installed at the labyrinth crest tips from the second to the seventh step in three arrangements: horizontal, vertical, and zigzag. The model consisted of seven 6-cm-high steps and was tested on two slopes, 1:1 and 1:0.7. Observations were made using high-speed videography at 240 fps, and the flow regime was quantified using the yc/h parameter, based on the disappearance of the stable air cavity and the formation of a continuous pseudo-bed. The addition of sills, particularly in the zigzag arrangement, accelerated the transition from nappe to skimming flow. The greatest reduction in skimming-flow onset discharge (about 38% relative to the baseline model) occurred on the 1:1 slope with 3.0-cm sills in the zigzag arrangement. On the 1:0.7 slope, the effect of the sills was more limited (5–12%). The zigzag arrangement exhibited the most complex three-dimensional pattern, with sequential jet deflection and helical flow paths, whereas the vertical arrangement had the least effect.
Keywords
Subjects